Installation method of the eight hole pad of the reducer coupling and motor shaft coupling

Ball mill's reducer are mostly used for driving equipment of low speed and large torque, the motor internal combustion engine or other high-speed operation of power through a less number of gear reducer input shaft tooth engages the output shaft of the gear to achieve speed and ordinary reducer will also have several pairs of the same principle to achieve the ideal reduction gear effect, the size of the gear ratio of the number of teeth is the transmission ratio.

1 reasonable selection of lubricating oil, especially the input power is greater than 11kw of the motor to be injected in the load gear oil. Often check the lubricating oil, hydraulic oil, coolant, oil level and quality, and pay attention to check the seal. Inspection found that the lack of oil, should analyze the reasons. At the same time, should strengthen the lubrication of all the lubrication points, the proposal in the running in period, every week to lubricate the grease. When the vertical belt pump is connected to the power source, the pump rotates in the direction of the oil pump.

2 in the motor to keep the motor clean, timely adjust, fastening loose parts, in order to prevent the loss of parts due to the loose or cause the loss of parts.

3 in the end of the run in period, to deal with the machine to carry out compulsory maintenance, good inspection and adjustment work, at the same time pay attention to the replacement of oil. In short, the use of the maintenance requirements of the reducer in the running in period, can be summarized as: strengthen the training, reduce the load, pay attention to check, strengthen lubrication. As long as we pay attention to and carry out the maintenance and maintenance of the reducer in the period of running, it can reduce the occurrence of early failures, prolong the service life, improve production efficiency, so that the speed reducer can bring more benefits for you.