Anhui Wannan motor mould workshop using wire cutting new technology by reducing cost and increasing quality

Under the production of die cast aluminum rotor, has been using the traditional EDM machine tool to process, the latter need to be fitter by hand grinding and polishing. The traditional processing method not only has a long processing time, and the precision is not high, at the same time, in the process of processing graphite electrode consumption generated waste residue pollute the environment.

According to the above adverse factors, Wannan motor mould workshop since the introduction of new line cutting and machining center, improved processing methods of cast aluminum mould, cutting out the fin taper slot rotor cast aluminum mould with the line, at the same time with the machining center processing the arc transition aluminum groove taper groove bottom edge of the corner, with the processing the method, not only shorten the processing cycle, saving the cost of the motor, an environmental protection, lowering cost and improving quality, reducing dependence on skilled workers, and the processing precision cast aluminum mould and surface quality improved significantly.